Original (When A Reversing Automatic Document Feeder Is Installed) - Sharp AR-C260 Network Scanner Operations

SENDING AN IMAGE
BASIC TRANSMISSION METHOD
Make sure the machine is in scanner
1
mode.
Load the original.
2
NOTE
You cannot load documents in both the reversing
automatic document feeder and on the document
glass and send them in a single transmission.
3 Check the original size.
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO A4
ORIGINAL
NOTE
G To scan a two-sided original (when a reversing
automatic document feeder is installed), refer to
page 19.
G To rotate the document image 90° before
transmission, see page
4 If needed, adjust the resolution setting.
(Refer to page 22.)
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO A4
ORIGINAL
When the [IMAGE
SEND] key light is on,
the machine is in
scanner mode. If the
light is not on, press the
[IMAGE SEND] key.
For detailed information
on loading an original,
refer to page 4-6 of
"Operation manual (for
general information and
copier operation)".
The original size is
automatically detected.
If you loaded a non-
standard size document
or wish to change the
scanning size, touch the
[ORIGINAL] key and set
the document size.
(Refer to page 20.)
20.
The initial factory setting
is "LOWER".
TABLE OF CONTENTS
If needed, adjust the exposure setting.
5
(Refer to page 21.)
AUTO
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO A4
If needed, select the file format. (Refer to
6
page 23.)
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO A4
ORIGINAL
7 Touch the [SENDER LIST] key.
DIRECTORY
ADDRESS REVIEW
SENDER LIST
-MAIL ADDRESS
NOTES
G You can omit selection of a sender (go directly to
step 10). In this case, the default sender
information stored with the key operator program
is automatically transmitted.
G Up to 20 senders can be stored using the Web
page. (page 12)
8 Touch a key to select a sender.
DER LIST
1 GROUP
SHARP PPD
2 GROUP
9 Touch the [OK] key.
OK
1 GROUP
16
The initial factory setting
is "AUTO".
The initial factory setting
is "PROGRAMMED".
This step is not
necessary for Scan to
FTP or Scan to Desktop.
Go directly to step 10
(page 17).
(page 38)
The touched key is
highlighted. If you made a
mistake, touch the correct
key. The highlighting will
move to the new key.
The selected sender will be
the sender of the e-mail.