Condition Setting Screen Of Scanner Mode; Sending An Image - Sharp AR-C260 Network Scanner Operations

CONDITION SETTING SCREEN OF SCANNER MODE

The condition setting screen of scanner mode is displayed by pressing the [IMAGE SEND] key (refer to page 1-8 of
"Operation manual (for general information and copier operation)") while the print mode, copy mode, or job status
screen appears in the touch panel. In the explanations that follow, it is assumed that the initial screen that appears
after pressing the [IMAGE SEND] key is the condition setting screen (shown below). If you have set the display to
show the address directory (following page) when the [IMAGE SEND] key is pressed, touch the [CONDITION
SETTINGS] key in the address directory to display the condition setting screen.
The key operator program
screen (shown below) or the
(refer to page 37).
NOTE
For information on the parts of the unit and the operation panel that are used for network scanning, refer to pages
1-7 and 1-8 of Operation manual (for general information and copier operation). For parts that are used for both
network scanning and printing, refer to chapter 3 of "Operation manual (for printer)".
I I I I Condition setting screen
The display is initially set (factory setting) to show the following condition setting screen as the initial screen.
Message display
Messages appear here to indicate the current
status of the machine.
[ADDRESS DIRECTORY] key
This displays the Address Directory screen (next
page). Touch this key when you wish to use a one-
touch key that has a destination (or group)
programmed in it.
[ADDRESS REVIEW] key
When performing Scan to E-mail broadcast
transmission, touch this key to check your selected
destinations. Your selected destinations will
appear as a list, and the list can be edited.
[SENDER LIST] key (page
Touch this key to select the sender when sending
an image.
[E-MAIL ADDRESS] key
When performing Scan to E-mail, touch this key if
you wish to enter the e-mail address of the
recipient manually instead of using an one-touch
key.
"Default display settings" can be used to set the display to show either the condition setting
Address directory screen
READY TO SEND.
AUTO
EXPOSURE
LOWER
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO
ORIGINAL
(page 17)
(page 18)
16)
(page 18)
TABLE OF CONTENTS
(following page) when the [IMAGE SEND] key is pressed
ADDRESS
DIRECTORY
ADDRESS REVIEW
E-MAIL ADDRESS SENDER LIST
Two-sided scanning icon display
Icons appear here when you touch the [ORIGINAL]
key and select two-sided scanning (when a
reversing automatic document feeder is installed).
The icons can be touched to open function
selection screens.
[ORIGINAL] key
Touch this key when you wish to manually set the
size of the original to be scanned or scan both
sides of the original.
[FILE FORMAT] key
Touch this key to set the file format of scan images
that you transmit. The selected file format setting
will be highlighted above the key. The initial factory
setting is "PROGRAMMED".
[RESOLUTION] key
Touch this key to change the resolution setting for
the original to be scanned. The selected resolution
setting will be highlighted above the key. The initial
factory setting is "LOWER".
[EXPOSURE] key
Touch this key to change the exposure setting for
the original to be scanned. The selected exposure
setting will be highlighted above the key. The initial
factory setting is "AUTO".
14
(page 19)
(pages 19 - 20)
(page 23)
(page 22)
(page 21)