Checking The Input Signal And The Lamp Usage Time; Automatic Power Shutoff Function - Sharp Notevision PG-C20XA Operation Manual

Checking the Input Signal and the Lamp Usage Time

Projector
ON/OFF
LAMP
POWER
TEMP.
KEYSTONE
INPUT AUTO SYNC
BACK ENTER MENU
(GUI) On-screen Display

Automatic Power Shutoff Function

Projector
ON/OFF
LAMP
POWER
2, 3, 4
TEMP.
KEYSTONE
2, 3
INPUT AUTO SYNC
1, 5
BACK ENTER MENU
(GUI) On-screen Display
Remote control
2
2
1
Remote control
This function allows you to check the current input signal
information and the accumulated lamp usage time.
1 Press MENU.
2 Press ∂/ƒ to select "Options", and then press
ENTER. The current input signal information and
the lamp usage time will be displayed.
• It is recommended that the lamp be replaced after
approximately 1,400 hours of usage. See pages 40 and 41
for lamp replacement.
When no input signal is detected for more than 15
minutes, the projector will automatically shut off.
Description of Automatic Power Shutoff
Power automatically shuts off after 15 minutes without
ON
a signal being input.
Automatic Power Shutoff disabled.
OFF
1 Press MENU.
2 Press ∂/ƒ to select "Options", and then press
ENTER.
3 Press ∂/ƒ to select "Auto Power Off", and then
press ENTER.
4 Press ∂/ƒ to select "ON" or "OFF".
5 To exit from the GUI, press MENU.
• "Auto Power Off" is factory preset to "ON".
34