Resetting The Lamp Timer - Sharp Notevision PG-C20XA Operation Manual

Replacing the Projection Lamp
7 Remove the lamp cage cover.
Turn over the projector and loosen the user service
screw that secures the lamp cage cover. Then lift
open the cover in the direction of the arrow.
9
Insert the new lamp cage.
Press the lamp cage firmly into the lamp cage
compartment. Fasten the securing screws.

Resetting the lamp timer

1 Connect the power
cord.
Plug the power cord into the AC
socket of the projector.
• Reset the lamp timer only after replacing the lamp.
41
8 Remove the lamp cage.
Loosen the securing screws on the lamp cage.
Hold the lamp cage by the handle and pull it
towards you.
10
Slide the lamp cage cover in the direction of the
arrow. Then tighten the user service screw.
2 Reset the lamp timer.
1 Press KEYSTONE ∂ and
KEYSTONE ƒ on the projector at
the same time.
2 Press INPUT and AUTO SYNC on
the projector at the same time.
3 Press AUTO SYNC and MENU on
the projector at the same time.
1
INPUT AUTO SYNC
BACK ENTER
2
Attach the lamp cage cover.
"LAMP 0000H" is
displayed, indicating that
the lamp timer is reset.
MENU
3