Checking The Input Signal And The Lamp Usage Time; Automatic Power Shutoff Function - Sharp Notevision PG-C20XE Operation Manual

Checking the Input Signal and the Lamp Usage Time

Projector
ON/OFF
LAMP
POWER
2
TEMP.
KEYSTONE
2
INPUT AUTO SYNC
1
BACK ENTER MENU
(GUI) On-screen Display

Automatic Power Shutoff Function

Projector
ON/OFF
LAMP
POWER
2, 3, 4
TEMP.
KEYSTONE
2, 3
AUTO SYNC
INPUT
1, 5
BACK ENTER MENU
(GUI) On-screen Display
This function allows you to check the current input signal
Remote control
information and the accumulated lamp usage time.
1 Press MENU.
2 Press ∂/ƒ to select "Options", and then press
• It is recommended that the lamp be replaced after
approximately 900 hours of usage. See pages 40 and 41
for lamp replacement.
Remote control When no input signal is detected for more than 15
minutes, the projector will automatically shut off.
Description of Automatic Power Shutoff
ON
OFF
1 Press MENU.
2 Press ∂/ƒ to select "Options", and then press
3 Press ∂/ƒ to select "Auto Power Off", and then
4 Press ∂/ƒ to select "ON" or "OFF".
5 To exit from the GUI, press MENU.
• "Auto Power Off" is factory preset to "ON".
ENTER. The current input signal information and
the lamp usage time will be displayed.
Power automatically shuts off after 15 minutes without
a signal being input.
Automatic Power Shutoff disabled.
ENTER.
press ENTER.
E-34