Specifications; Set-Up; Installing The Box Bracket; Installing The Control Box - JUKI SC-810 Instruction Manual

!. SPECIFICATIONS

Supply voltage
Frequency
Operatng envronment
Input

@. SET-UP

Install the motor unt to the control box followng the nstructons below.

1. Installing the box bracket

2

2. Installing the control box

1
Sngle phase 220 to 240V
50 Hz / 60 Hz
Temperature : 0 to 40˚C
320VA
Fx box bracket, rght 1 and box bracket, left 2 n
the direction as shown in the figure using the bolts
1
suppled wth the unt as accessores.
Install the control box on the table with the fitting bolt
asm. suppled wth the unt as accessores.
At ths tme, nsert the nuts and washers suppled
with the unit as accessories as shown in the figure
so that the control box can be securely fixed on the
table.
) Press three bolts 1 suppled wth the unt as ac-
cessores nto the hangng bolt hole n the table
and fix them.
2) Temporarly tghten convex washer, sprng wash-
er and nut on the sde where two bolts are at-
Nat
tached.
Spring 3) Hang the control box to the washer whch has
washer
Convex been temporarly tghtened, and attach convex
washer
washer, sprng washer and nut to the other bolt
on the opposte sde.
4) After adjustng the nstallng poston of the con-
trol box, securely tghten the respectve nuts.
–  –
Humidity : 90% or less