Setting For Functions Of Sc-810 - JUKI SC-810 Instruction Manual

3. Setting for functions of SC-810

Functions can be selected and specified by means of the four setting switches and light emitting diode lo-
cated inside the front cover of the SC-810.
(Caution) • Do not perform switch operations other than those described in the following explanations.
• Be sure to re-turn the power switch ON after one second or more has passed. If the power is
turned ON immediately after turning it OFF, the sewing machine may not work normally. In this
case, turn ON the power again.
5
6
Specified No.
1 Switch for entering specified value changed
and updating setting No. in DOWN direction
2 Switch for entering specified value changed
and updating setting No. in UP direction
How to change over to the function setting mode
) Turn OFF the power to the unt.
2) Pressng
4
3) Indcaton 5 and 6 wll be shown on the screen
* If the ndcaton fals to change, re-perform the
– 4 –
Specified value
1 2
swtch 4 , turn ON the power to the
unt.
dsplay.
(The ndcaton tem shows the tem, the settng
of whch was changed the last tme.)
procedures ) and 2).
3 4
3 Down switch (DOWN)
4 Up switch (UP)