Replaclng The Fluorescent Lamp Backlight 51 Before Requesting Service - Sharp Viewcam VL-H410X Operation Manual

service, please
Before calling for check the following troubleshooting table.
Power
The battery pack is not charged.
The power source is not correctly
connected.
Depleted battery pack.
Power goes off soon
after coming on.
Dew in VIEWCAM
Power on but no
Recording
image on the monitor.
Erasure protection hole is covered.
Cannot record
Poor colour TV not properly adjusted.
White balance is set improperly.
Poor lighting.
Dust or other foreign matter on lens.
Fuzzy picture
Not properly focused.
High-speed shutter is set to high
Monitor picture is
too speed
dark.
Monitor picture not Inappropriate picture adjustments
Playback
Old or worn tape
The infrarec remote control The lithium battery has run down.
does not function.
The remote control is being used
beyond its operating range.
Intense daylight is falling on the
There is an obstacle between the
remote control and the VIEWCAM's
photoreceptor.
Cassette cannot be inserted. Cassette is not right side up or is
backwards.
Another cassette is in the unit.
Cassette won't eject.
mode.
No tape movement in Fast Forward mode. Tape is already completely wound.
No taoe movement in Rewind mode. Tape is alreadv completely rewound.
This unit is equipped with a microprocessor. Its performance could be adversely affected by external
l
noise or interference. If this should happen, turn off the power, and disconnect the unit from any power
sources, including lithium batteries, etc. Then reconnect the power sources (to resume operation).
If the characters displayed on the monitor appear to malfunction, disconnect the power source and
l
remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the power
on again. When the characters on the monitor becomes normal, set the date and time; then resume
operation.
into the wall outlet again. (p. 11)
Charge the battery pack syfficiently. (p. 11)
Connect the power source'correctly.
(PP.139 14)
Use a fully charged battery pack. (p. 11)
Wait until dew dries. (p. 2)
Slide the Operate switch to CAMERA. (p. 22)
Slide the red projection to open the hole. (p. 5)
Adjust the TV. (See TV operation manual.)
Reset the white balance or set the VIEWCAM
to Full Auto mode. (p. 22, 41)
Apply additional lighting or correct
temperature of lighting. (p.45)
Clean the lens.
Adjust the focus or set the VIEWCAM to Full
Auto mode. (p.22)
Set the VIEWCAM to Full Auto mode. (p.22)
mode.
Adjust the picture. (p.20)
Reconnect properly. (p. 46)
Tune TV to RF converter's output channel
(VHF channel 0 or 1). (p.48)
Set TV's TV/VIDEO switch to the VIDEO
position if the AV input is used. (p. 46)
Make sure the white balance is properly
adjusted during recording. (p. 41)
Call for service.
Use a new
Replace the lithium battery with a new one.
Use the remote control within its operating
range. (p. 36)
Avoid letting intense daylight fall on the
Remove the obstacle or use the remote contr
from a different angle. (p.36)
Check cassette positioning and reinsert.
Press the EJECT button and remove. (p.15)
Press REC START/STOP button to stop
recording and try again. (p.22)
Rewind to desired point. (p. 31)
Fast forward to desired point. (p. 31)
video cassette. (p. 5)
52