Recording From An External Source; To Stop Recording - Sharp Viewcam VL-H410X Operation Manual

Set the OPERATE switch to VCR
Yellow: To VIDEO terminal
Red: To AUDIO (R) terminal
White: To AUDIO (L) termi
socket ,/
S-VIDEO cable (supplied
accessory)
To S-VIDEO
input
terminal
TV
Audio/video cable
(supplied accessory)
Video disc player .,..
Yellow: 1 o VIDEO OUT terminal
Red: To AUDtO OUT (R) terminal
White: To AUDIO OUT (L) terminal
3
REC button
RECORDING FROM
EXTERNAL SOURCE
You can record or edit on this VIEWCAM from other
sources such as a VCR, TV, or vi@eo disc player.
nal
Connect the VIEWCAM to the source equipment with
the supplied audio/video cable as shown to the left.
Notes:
If the source equipment has an S-video output terminal,
l
connect it to the ViewCamport's S-video socket with the
supplied S-video cable.
If the source equipment has only one audio output
l
terminal, connect the whtte plug to that terminal, and
leave the red one unplugged.
. While the S-video cable is plugged into the
ViewCamport's S-video socket, the VIDEO terminal does
not accept recording signals. (Audio signals can be
recorded.)
When you wish to record through the VIDEO terminal, be
sure to leave the S-video socket unplugged.
TO RECORD FROM AN EXTERNAL
SOURCE
Set the Operate switch to VCR.
Start sending audio/video signals from the
source equipment connected to the VIEWCAM.
Check on the VIEWCAM's monitor to see if the
picture is properly received.
Press the REC button on the VIEWCAM to start
recording.
Note:
To pause recording, press the PAUSE/STILL button on
l
the VIEWCAM. Press the PAUSE/STILL button again to
resume recording.

TO STOP RECORDING

Press the STOP button on the VIEWCAM.
AN
50