Fluorescent Lamp Backlight - Sharp Viewcam VL-H410X Operation Manual

Fluorescent lamp
Fluorescent lamp
compartment cover
, Fluorescent lamp
51
The fluorescent lamp backlight used in the
If you continue to use the VIEWCAM when the
fluorescent lamp has almost reached the end of its
service life, the "REPLACE THE? LAMP." indicator will
appear on the monitor, and the monitor will turn off
approximately one minute later.
When this occurs, purchase a replacement lamp
Line Parts Distributor, and replace the old lamp.
REPLACING THE FLUORESCENT
LAMP BACKLIGHT
Set the Operate switch to OFF to turn off the
lamp unit to cool down.
Rotate the lens part of the VIEWCAM halfway
forward in the drrection of the arrow, and then
remove the fluorescent lamp compartment cover.
Carefully hold the end (white knob) of the
fluorescent lamp unit with tweezers, and pull the
lamp unit out.
Insert the replacement fluorescent lamp unit into
the compartment. See note below.
Replace the fluorescent lamp compartment
cover.
Notes:
Be
sure to Insert the replacement fluorescent lamp
l
straight in, In the direction of the arrow, into the
compartment. Do not press dragonally as this may cause
contact farlure.
Should this occur, turn off the VIEWCAM, and then turn It
on again.
Cautions:
use of the VIEWCAM. Wait at least 15 minutes after
turning the power off before attempttng to change the
lamp, to allow time for it to cool down.
@Attempting to change the fluorescent lamp while it
in burns or other injuries.
hot may result
,
IS