Sharp Viewcam VL-H410X Operation Manual page 36

1
button
35
USING THE COUNTER
MEMORY
Use the counter memory when you want to return to
the beginning of a particular scene. The position
where the counter memory was reset (0:OO 00) is
stored in memory to make it easier to return the tape
to that point.
Press COUNTER button to make
the
memory display appear on the monitor.
Press the MEMORY button to set the counter to
Counter Memory mode. "M" will be displayed to
the left of the counter.
Then press the COUNTER button to turn off the
counter control button indicators.
During playback (or recording), press the RESET
button to reset the counter to zero at the
beginning of a scene that you want to return to
later. Then press the COUNTER button to turn
off the counter control button indicators.
Stop playback (or recording). If the VIEWCAM is
in the Camera mode, set the Operate switch to
VCR. Then press the REW button. The tape will
automatically stop when the counter reaches
desired scene.
Notes:
The FF (Fast Forward) button can be used In the same
l
way.
This functiori does not work during video searches.
l
To Cancel Counter Memory Mode
Press the COUNTER button to make the counter
display appear and then press the MEMORY button
to turn off the "M" to the left of the counter display.
The Counter Memory mode is turned off, and the
counter returns to Ordinary Counter mode.
To turn off the Counter mode, press the COUNTER
button. The counter display will turn off.
counter
the