Table of Contents
Advertisement
101
VL-PD6H/093-103
Downloaded from:
http://www.usersmanualguide.com/
Appendix
Before Requesting Service
The following conditions do not always denote trouble. Therefore, perform the checks described below
before calling for service. If the problem cannot be corrected by the use of this guide, remove the mains
plugs from the wall socket, and contact the dealer or supplier from whom the unit was purchased in
order to obtain service. Where this is not possible, please visit our web-site www.sharp.co.uk/support.
Customers without Internet access may telephone 08705 274277 during office hours (or (01)676 0648 if
telephoning from Ireland).
Certain replacement parts and accessories may be obtained from our main parts distributor, who can be
contacted on the following numbers:
W
ILLOW
In the unlikely event of this equipment requiring repair during the guarantee period, you will need to
provide proof of the date of purchase to the repairing company. Please keep your invoice or receipt,
which is supplied at the time of purchase.
Symptom
No power.
Power source is not properly connected.
Battery pack is not charged.
Dew in camcorder.
Safety function is in effect.
REC START/STOP button does
Erasure protect tab on video cassette is open.
not work.
Power suddenly turns off.
Camcorder left in Recording Standby mode for 5
minutes in Tape Recording mode.
Auto focus does not work.
Manual Focus mode is engaged.
Zoom used on close subject.
Subject has little contrast in brightness, or is full
of horizontal or vertical stripes.
Bright subject produces wide
Occurs when shooting subject with strong
vertical lines.
contrast to the background. Does not indicate a
malfunction.
Automatically zooms out without
Camcorder is unable to focus when zooming in
operating Power Zoom buttons.
on subject within 1.5 m, and automatically
zooms out until it focuses on subject.
No subject in the field of view.
On-screen displays
Camcorder is in Demo mode.
automatically change.
101
V
E
L
.: 0121 766 5414
ALE
LECTRONICS
TD
Possible cause
Connect power source properly (pp. 10, 11).
Charge battery pack sufficiently (p. 9).
Wait until dew dries (p. 98).
Set Power switch to OFF and remove battery
pack; wait for 2 seconds, then reinstall battery
pack and turn on power (p. 10).
Close tab or use a new cassette (p. 95).
Set Power switch to OFF and then back to
CAMERA.
Set to Auto Focus mode (p. 50).
Zoom out from subject (p. 20).
Focus manually (p. 49).
Direct lens to some subject, or set zoom to
widest angle before shooting (p. 20).
Set DEMO MODE menu item to "OFF" (p. 100).
Suggested solution
——
——
01.4.24, 0:45 PM
Advertisement
Table of Contents
