Troubleshooting - Sharp XV-Z10E Operation Manual

Troubleshooting

Problem
Projector does not start or
there is no picture and no
sound.
Sound is heard but no
picture appears.
On-screen display does
not appear.
Colour is faded or poor.
Picture is blurred;
noise appears.
Picture appears but no
sound is heard.
An unusual sound is
occasionally heard
from the cabinet.
Maintenance
indicator illuminates.
Remote control does not
operate.
• Projector power cord is not plugged into the wall outlet.
• Power to the external connected devices is off.
• The selected input mode is wrong.
• The MUTE function is working.
• Cables incorrectly connected to rear panel of the projector.
• Remote control batteries have run out.
• The filter cover or the lamp unit cover is not installed correctly.
• Cables incorrectly connected to the rear panel of the projector.
• "Bright" is set to minimum position.
• "OSD Display" is set to "
• Picture adjustments are incorrectly set.
(Video Input only)
• Video input system is incorrectly set.
(INPUT 1 only)
• Input signal type (Component/RGB) is incorrectly set.
• Adjust the focus.
• The projection distance exceeds the focus range.
(Computer Input only)
• Perform "Fine Sync" Adjustments ("Clock" Adjustment)
• Perform "Fine Sync" Adjustments ("Phase" Adjustment)
• Noise may appear depending on the computer.
• Cables incorrectly connected to rear panel of projector.
• Volume is set to minimum.
• If the picture is normal, the sound is due to cabinet shrinkage
caused by room temperature changes. This will not affect
operation or performance.
• See "Maintenance Indicators".
• The batteries in the remote control have run out.
• The batteries are inserted incorrectly into the remote control.
Check
" (OFF).
Page
20
—
27
28
20-25
15
56, 62
20-25
42
47
42
48
44
30
17
45
45
—
20-25
27
—
52
15
-63