Resetting The Lamp Timer - Sharp XV-Z10E Operation Manual

Regarding the Lamp
5
Remove the lamp unit.
• Loosen the securing screws from the lamp
unit. Hold the lamp unit by the handle and
pull it in the direction of the arrow. At this
time, keep the lamp unit horizontal and
do not tilt it.
6
Insert the new lamp unit.
• Press the lamp unit firmly into the lamp
unit compartment. Fasten the securing
screws.
7
Replace the lamp unit cover.
• Align the tab on the lamp unit cover (1)
and place it while pressing the tab (2) to
close it. Then tighten the user service
screw (for lamp unit cover) (3) to secure
the lamp unit cover.
Info
• If the lamp unit and lamp unit cover are not
correctly installed, the power will not turn on,
even if the power cord is connected to the
projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.
1
Connect the power cord.
• Plug the power cord into the AC socket of
the projector.
• Make sure that the power indicator on the
projector illuminates in red.
2
Reset the lamp timer.
• Press
, ,
the projector in order, and then press
on the projector.
• "LAMP 0000H" is displayed, indicating that
the lamp timer is reset.
Info
• Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this may
cause the lamp to become damaged or ex-
plode.
-56
, , , and on
Securing screws
1
2
User service screw
(for lamp unit cover)
AC socket
Handle
3