HAMPTON BAY Hamilton HI300 Owners & Installation Manual page 16

installation
SIDE CAST ADJUSTMENTS
If unable to align side faceplate to unit and top
faceplate further adjustments need to be made, complete one
side at a time. Loosen all bolts on brackets (6 per side). Loosen
top and bottom bolts (Shown below).
Adjust left or right side cast plates to allow further adjustment on
faceplate. Once aligned, hold side surround in place and tighten
all bolts. If side cast height needs adjusting, loosen 2 bolts holding
cast bracket and adjust up or down.
Cast
mounting
bolts
for height
adjustment.
See Step 1 to identify side casts.
See next section for recommended measurements.
16
918-967
RECOMMENDED MEASUREMENTS
FOR SETTING SIDE CASTS
Enamel & Cast components are very fragile.
Use extreme care when handling.
Left Side
Cast
Cast
adjustment
bolts
1/8" - 1/4" (approx.) for both sides,
between ashlip and bottom of side cast.
4-1/2" - 4-3/4" boths sides rear inside edge to fi rebox.
Important: Verify gap between cast and door did not
change when rear adjustments have been made.
Carefully open door slowly, to ensure that the door does
not rub against cast sides.
*
These are just recommended measurements.
3
Stop! Read Carefully.
1/4" (approx.) between both
sides of door and cast.
Rear View of Unit
Hampton HI300 Wood Cast Insert
HI300
Right Side
Cast
05/02/11