Oversize Cast Faceplate Installation - HAMPTON BAY Hamilton HI300 Owners & Installation Manual

installation
Enamel & Cast components are very fragile. Use extreme care when handling.
FACEPLATE CONTENTS LIST
Qty Description
Left Side Faceplate
1
1 Right Side Faceplate
1 Top Faceplate
2 Side Mounting Brackets
1/4" - 20 x Hex Nuts
2
2 1/4" - 20 x 1" Hex Head Bolts
2 1/4" Flat Washers
2 47" Insulations
1 8 mm gasket
1) Secure the Side Mounting Brackets (packaged with Faceplate) to the
left and right side of the fi rebox using 2 bolts per mounting bracket
as shown in the diagram below. Bolts are pre-installed on unit.
Leave bolts loose until fi nal adjustment is made.
Side Mounting
Bracket
Backside of Unit Shown.
14
918-967

oVersize cast faceplate installation

OVERSIZE CAST FACEPLATE INSTALLATION
Stop! Read Carefully.
2) Secure the Left and Right Side Faceplate to the fi rebox by aligning
the Mounting Holes with the Side Mounting Brackets taking care to
align vertically while each side rests on the hearth. Secure using 2
bolts per bracket.
Side Mounting
Bracket
Right Side Face-
plate
Backside of Unit & Faceplate Shown.
3) Place 1- 1/4" x 1" Hex head bolt with 2 washers in Mantel Top
Spacer location shown below.
4) Place Mantel Top onto the top of the fi rebox.
Mantel Top Spacer
With the Mantel Top in place check to make sure there is no gap
between the Mantel Top Spacer and the underside cast of the Mantel
Top. If there is a gap present you will need to lower that side cast by
loosening 2 bolts, see side cast adjustment section for bolt location
(check to see if level).
1
HI300
Mounting
Hole
Left Side Face-
plate
Mantel Top
Right Side
Cast
Hampton HI300 Wood Cast Insert
05/02/11