HAMPTON BAY Hampton HI200 Owners & Installation Manual page 19

The door latch or door alignment may require adjustment as the door gasket material compresses after a few fires. Removal of spacers will allow
the latch to be moved closer to the door frame, causing a tighter seal and the ability to raise or lower the latch assembly.
1) Raise or lower the latch by undoing the inner 2 bolts. Adjust to
desired location and retighten the 2 bolts, make sure the door catch
closes freely and makes a good seal. Do a paper test to confirm seal.
2) For Door Gasket Seal, remove the Latch Assembly from the unit by
undoing the outer 2 bolts.
Latch
Assembly
HI200 Hampton Wood Cast Insert
LATCH ADJUSTMENT
Mounting
Latch
Bracket
Latch Assembly
removed from unit.
3) Remove necessary amount of spacers sitting on the Mounting
Bracket.
Ensure an equal amount of spacers are removed from both
top and bottom.
4) Re-secure Latch to Mounting Bracket using 2 bolts
Latch Assembly re-assembled with
5) Re-secure the Latch Assembly to the unit using 2 bolts.
Confirm proper location of the door catch so that it closes tight,
freely.
MAINTENANCE
Mounting
Bracket
Spacers
spacers removed.
19