Resetting The Lamp Operating Time - Epson EMP-53 User Manual

Maintenance Maintenance

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp
operating time. When the cumulative operating time reaches a certain
point, it causes the replacement warning message to be displayed.
Therefore, the counter needs to be reset after the lamp has been replaced
with a new one. You can do this using the configuration menu.
Use the remote control to carry out the operations for resetting the lamp
operating time.
TIP
Do not reset the lamp operating time except after the lamp has been
replaced, otherwise the lamp replacement period will not be indicated
correctly.
PROCEDURE
Connect the power cable, turn on the projector's
1
power, and then press the [Menu] button on the
remote control.
The configuration menu will be displayed.
Remote Control
Menu A/V Mute Freeze
E-Zoom
Enter
Select "Reset Lamp Timer" from the "About" menu
2
and then press the [Enter] button.
:
Lamp 1400H
Reset Lamp Timer :
:
Video Source Computer
:
Input Signal RGB
:
Frequency H ---.--kHz
:
V ---.--Hz
:
SYNC Polarity H ------
: V ------
:
SYNC Mode ------
:
Resolution 0x 0
:
Refresh Rate 0.0 Hz
Select "Yes" and then press the [Enter] button.
3
The lamp operating time will then be reset.
Reset Lamp Timer Reset Lamp Timer
Execute? Execute?
YES YES
Execute
NO NO
79