Epson EMP-53 User Manual page 29

Turning On the Projector
If more than one signal source has been connected,
4
use the projector's control panel or the remote
control buttons to select the port which the signal
source that you would like to use is connected to,
while referring to the following table.
Projector
Button to press
Port
Projector
The image
Computer/
source changes
Component Video
each time
[Source] is
S-Video pressed.
Video
* The items selected using the "Input Signal" command in the "Video"
menu will appear.
Remote control
Page down Page up Power
Computer S-Video/Video Color Mode
Menu A/V Mute Freeze
E-Zoom
Enter
Display at top-right
Remote
of screen
control
Computer *
Component Video
[Computer] (YCbCr ) *
Component Video
(YPbPr ) *
S-Video
[S-Video/
Video]
Video
TIP
• If only one signal source has been connected, the signals from that
source will be projected without needing to press one of the buttons
from the previous table.
• If the "No-Signal." message does not disappear, check the
connections again.
• If a laptop computer or a computer with an LCD screen has been
connected to the projector, the images may not be projected straight
away. After starting projection, check that the computer has been set
up to output signals externally.
The following table shows examples of how to toggle output settings.
For details, refer to the section of the documentation provided with
your computer under a heading such as "External output",
"Connecting an external monitor" or similar.
NEC Panasonic Toshiba IBM
[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]
• If the same still picture is projected for a long period of time, the
projected image may become burned in on the computer screen. You
should avoid leaving the same image displayed for long periods.
Sony Fujitsu Macintosh
After startup, change
the Control Panel
adjustments so that
Mirroring is active
28