Epson EMP-53 User Manual page 68

When the Indicators Provide No Help When the Indicators Provide No Help
Images are out of focus and distorted (not clear)
Has the focus been adjusted
correctly?
Is the lens cover still attached?
Has the front adjustable feet been
adjusted so that the image angle is too
big?
• • • •
The image is fuzzy
Is the projector at the correct
• • • •
Part of the image
distance?
is out of focus
• • • •
The whole image
Is the projector beam perpendicular to
is out of focus
the screen?
Is the lens dirty?
Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment,
Have the
"Position" been adjusted correctly?
Are the image signal format settings
correct?
"Sync. ", "Tracking " and
p.31
If the image angle is too big, the image will be out of focus vertically.
The recommended distance from the projector to the screen is within 89–1050 cm
(2.9–34.4 ft.). Set up the projector so that the projection distance is within this
range. p.14
p.32
p.74
condensation may form on the surface of the lens, and this may cause the images to
appear fuzzy. Set the projector up in the room approximately one hour before it is
to be used. If condensation forms on the lens, turn off the power and wait for the
condensation to disappear.
If the "Auto Setup" command in the "Video" menu is set to "OFF", press the
[Auto] button on the remote control to adjust these settings. If the images have not
been correctly adjusted after using the automatic setup function and after pressing
the [Auto] button, adjust the settings manually using the respective menus.
p.35, p.45
If a computer, component video
projector, use the "Input Signal" command in the "Video" menu to select the signal
format which matches the signal connected source.
If a composite video or S-Video
"Video Signal" command in the "Video" menu to select the video signal format.
p.48
or RGB video source is connected to the
p.46, p.48
source is connected to the projector, use the
67
p.32