Macro Programming Features - Yamaha DSP-AX861SE Owner's Manual

3
k / n to select and enter a character.
D
Press
n changes the character as follows:
D
Pressing
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),
/ (slash), and space.
k changes the characters in reverse order.
D
Pressing
PRESET/CH
ENTER
A/B/C/D/E
4
h to move the cursor to the next
D
Press
position.
PRESET/CH
ENTER
y
Press D l to move the cursor to the previous position.
ENTER to set the new name.
5
D
Press
"OK" appears in the display window (
remote control if renaming was successful.
"NG" appears in the display window(
remote control if renaming was unsuccessful. In this
case, start over from step 3.
y
If you continuously want to rename another input area, press
the input selector button ( B ),
J SELECT k / n repeatedly to select the component, then
repeat steps 3 through 5.
6
Press TRENAME again to exit the renaming
mode.
RENAME
Note
"ERROR" appears in the display window (J) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
y
This feature is useful when you change the input or output
assignment for digital jacks and component video input jacks.
Refer to "Input rename" on page 71.
A/B/C/D/E
J
) on the
J ) on the
, or , or press

Macro programming features

The macro programming feature makes it possible to
perform a series of operations with the press of a single
button. For example, when you want to play a CD,
normally you would turn on the components, select the
CD input, and press the play button to start playback. The
macro programming feature lets you perform all of these
operations simply by pressing the CD macro button. The
buttons listed as macro buttons below are factory set with
macro programs. You can also program your own macros
(see page 85).
■ MACRO operations
Macro buttons
POWER POWER STANDBY POWER
TV AV
SCENE
1 2 3 4
PHONO MULTI CH IN
V-AUX/DOCK MD/CD-R
TUNER CD
DTV/CBL DVR VCR DVD
MACRO ON/OFF
MACRO ON/OFF selector to ON.
1
T
Set the
OFF ON
2
Press the desired macro button.
MACRO ON/OFF selector to OFF
3
T
Set the
when you finish to using the macro
programming operation.
OFF ON
Notes
• While the remote control is running a macro program, it does
not accept any other operation until it has completed running
the program (the transmission indicator stops flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation is complete.
Remote control features
REC
FREQ/TEXT EON MODE- PTY SEEK- START
OFF ON MACRO LEARN CLEAR RENAME
MACRO
MACRO LEARN CLEAR
MACRO LEARN CLEAR
83
En