Yamaha DSP-AX861SE Owner's Manual page 93

4
Press the numeric buttons (
four-digit remote control code for the input
area you want to use.
CLASSICAL LIVE/CLUB
1 2
STEREO ENHANCER
5 6
9 0
Remote control AMP ID codes
Select one of the following codes to set the remote control
AMP ID code for the input area you want to use.
AMP ID code
Function
(remote control
setting)
2001 To operate this unit using the
(initial setting) default code.
2002 To operate this unit using an
alternative code.
ENTER to set the number.
5
D
Press
"OK" appears in the display window (
was successful.
"NG" appears in the display window (
setting was unsuccessful. In this case, start over from
step 1.
LEARN again to exit from the setup
6
Press T
mode.
LEARN
F
) to enter the
ENTERTAIN MOVIE
3 4
SUR. DECODE NIGHT
8
7
Remote
control AMP
ID
ID1
(initial setting)
ID2
J
) if setting
J ) if the
See page 89 for the operation of the advanced setup.
■ SCENE IR code setting
Use this feature to output the remote control signals at the
REMOTE OUT jack automatically when this unit is in the
SCENE mode.
Choices: ON, OFF
• Select "ON" when the component connected to the
REMOTE OUT jack is the Yamaha component and has
the capability of the SCENE control signals. This unit
automatically sends the remote control signals to the
component.
• Select "OFF" when the component connected to the
REMOTE OUT jack is not the Yamaha component and
does not have the capability of the SCENE control
signals.
Note
If noises are output when you operate the SCENE function, set
"SCENE IR" to "OFF".
■ Bi-amplifier setting
Use this feature to activate or deactivate the bi-amplifier
function (see page 14).
Choices: ON, OFF
• Select "ON" if you want to activate the bi-amplifier
function. "SUR.B L/R SP" is set to "NONE"
automatically, and this unit outputs the front channel
audio signals at the SURROUND BACK speaker
terminals.
• Select "OFF" if you want to deactivate the bi-amplifier
function.
Note
When "BI-AMP" is set to "ON", you can only select "FRONT B"
or "NONE" in "EXTRA SP ASSIGN" (see page 64).
■ Video parameter reset
Use this feature to initialize the "VIDEO CONV.",
"HDMI UP-SCALING", "HDMI ASP" and "OSD
SHIFT" settings in "DISPLAY SET" (see page 73).
Choices: YES, CANCEL
■ Monitor check
MON.CHK
Use this feature to activate or deactivate the monitor check
function of this unit. When this parameter is set to "YES",
this unit receives the information of the available video
signal resolutions from the video monitor connected via
HDMI (see page 73).
Choices: YES, SKIP
Advanced setup
SCENE IR
BI-AMP
V.RESET
91
En