Table of Contents
Advertisement
,_
WARNING:
The maximum
blade capacity
of your saw is 7-1/4 inches. Any
blade larger than 7-1/4 inch will come in contact with the blade guards. Never
use a blade that is so thick that it prevents the outer blade washer from engaging
with the flat side of the spindle.
Blades that are too large or too thick can result
in an accident
causing serious injury.
SAW BLADES
All saw blades need to be kept clean, sharp, and properly set in order to cut
efficiently.
Using a dull blade places a heavy load on the saw and increases the
danger of kickback.
Keep extra blades on hand, so sharp blades are always
available. Gum and wood pitch that have hardened
on the blade will slow
the saw. Use gum and pitch remover, hot water, or kerosene to remove these
substances.
Do not use gasoline.
BLADE GUARD SYSTEM
(Fig. 3)
The lower blade guard is there
for your protection
and safety.
It should never be altered for
any reason. If the lower blade
guard becomes
damaged
or begins to return slowly or
sluggishly,
do not operate
your saw until the damaged
part has been repaired or
replaced.
Always leave the
guard in its correct operating
position
when using the saw.
,_
DANGER:
When sawing
through a workpiece,
the
Fig. 3
Lower Blade Guard
level is in UP position
when making _
"-x
9n the underside
of the
lower blade guard does not cover the blade on the underside
of the workpiece.
Keep hands and fingers away from the cutting
area. If any part of your body
comes
in contact with the moving blade, serious injury will result.
,_, CAUTION:
Never use the saw when the lower blade guard is not operating
properly. The lower blade guard should be checked
for correct
operation
before
each use. If you drop your saw, check the lower blade guard and bumper for
damage at all depth settings
before using.
NOTE: The lower blade guard is operating
properly when it moves freely and
then readily returns to the closed position.
If, for any reason, your lower blade
guard and bumper do not close freely, take the saw to your nearest Craftsman
Repair Center for service before using it.
28195
Manual_Revised_07-0623
Page 16
Advertisement
Table of Contents
