Craftsman 320.28195 Product Manual page 19

8.
Keep the blade at the correct depth setting. The depth setting should not
exceed 1/4 inch below the material being cut (Fig. 6). Be sure that the blade
depth and adjusting locking levers are tight and secure before making a cut.
If blade adjustment shifts while cutting, it may cause binding and Kickback.
Fig. 6
I I
Correct Blade Depth Blade is Set Too Deep
KICKBACK
9. Use extra caution when making a "Pocket Cut" into existing walls or other
blind areas. The protruding blade may cut objects that can cause Kickback.
STARTING/STOPPING THE SAW
To start the saw: Depress the
trigger switch (Fig. 7).
Always allow the blade to reach
full speed, and then guide the
saw into the workpiece.
To stop the saw: Release the
trigger switch.
After you release the trigger
switch, allow the blade to
come to a complete stop.
Do not remove the saw from
the workpiece while the
blade is moving.
Fig. 7
Trigger Switch
28195 Manual_Revised_07-0623 Page 19