Craftsman 320.28195 Product Manual page 27

2. While holding the lower
blade guard up by the
lever, firmly rest the front of
the saw base flat against
the workpiece with the rear
handle raised, so that the
blade does not touch the
workpiece (Fig. 18).
3. Depress the trigger switch
to start the saw. Always
allow the blade to reach
full speed, and then slowly
lower the blade onto the
workpiece until the base is
flat against the workpiece.
Fig. 18 1
/
4. You must release the lower blade guard lever as the blade enters the material.
5. After you complete the cut, release the trigger switch and allow the blade to come
to a complete stop. After the blade has stopped, remove it from the workpiece.
6. If the corners of your pocket cut are not completely cut through, use a hand
finishing saw to finish the corners.
,_ WARNING: Never tie the lower blade guard in the raised position. Leaving
the blade exposed could result in serious injury.
HOOK (Fig. 19)
_I_ CAUTION: Always unplug
the saw before hanging the
saw with the hook.
CAUTION: Never hook
the saw in a high location
or on a potentially unstable
surface.
The hook is convenient for
temporarily hanging the saw.
To use the hook, simply lift up
the hook until it snaps into the
open position. When not in use,
always lower the hook until it
snaps into the closed position.
Fig. 19
Hook
28195 Manual_Revised_07-0623 Page 27