Bevel Stop - Craftsman 320.28195 Product Manual

0 ° BEVEL STOP
The saw has a 0 ° bevel stop that has been factory adjusted to assure a 0° angle
of the saw blade when making 90°cuts.
TO CHECK 0° BEVEL STOP
,_ WARNING: Always un-
plug the saw before making
any adjustments. Failure to
unplug the saw could result in
accidental starting, which can
cause serious personal injury.
1. Unplug the saw from the
power source.
2. Place the saw in an
upside-down position on
a workbench.
3.
Using a carpenter's
square, check that the
saw blade is square to the
base of the saw (Fig 16).
TO ADJUST 0° BEVEL
STOP (Fig. 17)
1. Unplug the saw from the
power source.
2. Loosen the bevel-
adjustment knob.
3. Locate the 0° bevel-stop
adjusting screw
4. Using a hex key, turn the
0 ° bevel-stop adjusting
screw until it is square
with the saw blade.
Fig. 16
Fig. 17 0° bevel-stop
adjusting screw
0 ° bevel stop
ustment screw
MAKING POCKET CUTS
WARNING: Always adjust the bevel setting to zero before making a pocket
cut. Attempting a pocket-cut at any other setting can result in a loss of control of
the saw, which can result in serious injury.
1. Adjust the bevel setting to zero, set the blade to the correct blade depth
setting, then use the lower blade guard lever to swing the guard up.
,_ WARNING: Always use the lever to raise the lower blade guard to avoid
serious injury.
28195 Manual_Revised_07-0623 Page 26