Table of Contents
Advertisement
7. After completing
your cut, release the trigger switch and allow the blade to
come to a complete
stop. Do not remove the saw from the workpiece
while
the blade is moving.
_,
DANGER:
When sawing through
a workpiece,
the lower blade guard does
not cover the blade on the underside
of the workpiece
(Fig. 3). Always keep your
hands and fingers away from the cutting area. Any part of your body coming
in
contact with the moving blade will result in serious injury.
MAKING
CROSS CUTS AND RIP CUTS
,_
WARNING:
Always securely
clamp and support the workpiece.
Always
maintain proper control of the saw. Failure to clamp and support
the workpiece
and loss of control of the saw could result in serious injury.
WARNING:
Always maintain proper control of the saw to make sawing
safer and easier. Loss of control of the saw could cause an accident
resulting in
possibly serious injury.
1. Always use your saw with
your hands positioned
correctly
(Fig. 11).
2.
When making cross or rip
cuts, align your line of cut
with the left side of the
notch by the 0 ° indicator.
(Fig. 11 a).
3.
Since the thicknesses of
blades vary, make a trial
cut in scrap material along
the guideline to determine
how much, if any, you
should offset the blade
from the guideline to allow
for the kerf of the blade and
make an accurate cut.
INTEG RATED
CROSSCUT
RULER
A ruler for measuring
cross
cuts is marked along the front
of the saw base.
MAKING
RIP CUTS
Fig. 11
Fig. 11a
Always
use a guide when
making long or wide rip cuts
with your saw. You can use
either a straight edge or use
the edge guide that was included with your saw.
i
i
,_
Line of Cut
u_
u
u
,
0 ° Indicator
28195
Manual_Revised_07-0623
Page 22
Advertisement
Table of Contents
