Cutting Crown Molding; Right Side - Craftsman 320.21195 Operator's Manual

CUTTING
CROWN MOLDING cont. (Fig. 18)
The settings in the table below can be used for cutting all standard (U S.) crown
molding with 52"_and 38 ° spring angles The crown molding is placed flat on the
miter table, using the compound features of your miter saw
Always use the hold down clamp, and place tape on the area being clamped to avoid
marks on the workpiece
Fig. 18 52° Catting
Wall
I TOp Edge Agains_ Fonce =
• Lo|_ Side, inside Corner
COMPOUND BEVEL/MITER SETTINGS
Key Bevel Miter
Settfng Setting
IL
tR
OL
OR
33.g _ 31 6 ° Right
33.9 _ 31 6 _ Left
33 9°` 31 6 _ Left
339" 31,6 _ Right
Type of cut
Inside corner _ Left side
1 Posltion top of molding agalnst fence
2. Miler table set at RIGHT 31.6 °
3 LEFT side is finished piece.
Inside corner - Right side
1 Position top of molding against fence
2 Miter table set at LEFT 31 6 °
3. LEFT side is finlshed piece,
Outside corner - Left side
1. Posftion top of molding against fence
2 Miter table set at LEFT 3I 6 °
3 RIGHTside is finished piece,
Outside corner - Right side
1 Position top of molding against fence
2, Miter table set at RIGHT 3I 6 °
3, RIGHT side Is finished piece
34