EPSON FX-2180 Service Manual
Figure 4-26. Removing the Right Frame Assembly
T
IMPORTANT
The tightening torque for the hexagonal nut is
1.18 - 1.37 Nm (12 - 14 Kgf-cm).
Adjust the platen gap/parallelism and
bidirectional print alignment, and reset the TPE
level. (See Chapter 5.)
4.2.11.6 Disassembling the Right Frame Assembly
Remove the printer cover, front and rear edge guide assemblies, front
1.
cover, paper eject assembly, and front and rear tractor units. (See
section 4.2.1.)
Remove the panel board assembly. (See section 4.2.2.)
2.
Remove the upper housing assembly. (See section 4.2.7.)
3.
Remove the printer mechanism. (See section 4.2.11.)
4.
Remove the PF motor assembly. (See section 4.2.11.2.)
5.
Remove the right sub frame assembly. (See section 4.2.11.4.)
6.
Remove the right frame assembly. (See section 4.2.11.5.)
7.
Remove the following 11 parts from the right frame assembly:
8.
2 compression springs (200 g)
2 spur gears (34.5 mm)
1 spur gear (27 mm)
1 combination gear (8 mm, 31.5 mm)
T
IMPORTANT
When assembling the right frame assembly,
attach the 11 parts listed in step 8 to the right
frame assembly as shown in the following
figures.
Chapter 4 Disassembly and Assembly
2 plain washers
1 spur gear (34 mm)
1 spur gear (21 mm)
1 intermittent gear
4-19