Removing The Print Head - Epson TM-FX2180 Service Manual

EPSON FX-2180 Service Manual

4.2.3 Removing the Print Head

Remove the printer cover and ribbon cartridge. (See section 4.2.1.)
1.
Remove the two CBS screws (3
2.
CR assembly.
Remove the print head from the CR assembly.
3.
Disconnect the two wide FFCs from the print head and then
4.
disconnect the narrow FFC from the connector on the CR cover.
Figure 4-6. Removing the Print Head
10) securing the print head to the
Chapter 4 Disassembly and Assembly
T
IMPORTANT
The FFCs must be connected properly, as
shown in Figure 4-7.
T
The tightening torque for the CBS screws is
0.59 - 0.78 Nm (6 - 8 Kgf-cm).
Perform the platen gap/parallelism, bidirectional
print alignment, factory settings, and TPE level
reset adjustments. (See Chapter 5.)
Figure 4-7. Connecting the Print Head FFCs
4-7