Epson Stylus Pro GS6000 User Manual page 74

EPSON Stylus Pro GS6000
Error messages
PAPER ERROR
LOAD PAPER PROPERLY
REFER TO THE MANUAL
PAPER OUT
LOAD PAPER
F/W INSTALL ERROR
UPDATE FAILED
RESTART THE PRINTER
PAPER JAM
REMOVE PAPER
CARRIAGE LOCKED
RELEASE THE CARRIAGE LOCK
PRINTER ERROR
RESTART THE PRINTER
MAINTENANCE REQUEST NNNN
SERVICE CALL ERROR NNNN
PLEASE CONTACT TO THE REPAIR
CENTER
User's Guide
Problem Solver
Description
The paper is not
loaded correctly.
No paper is loaded in
the printer.
The paper is not
ejected properly.
The roll paper runs out
while printing is in
progress.
The printer fails to
update the firmware.
The paper is jammed.
Print head is locked.
Some errors have
occurred.
A part used in the
printer has nearly
reached the end of its
life. "NNNN" shows the
code of the part.
If 1133 or 1137
appears, the print
head may be locked.
If 3000 appears, the
power cord is not
plugged into the
electrical outlet or the
AC inlet of the printer
properly.
A fatal error has
occurred.
74
What to do
Release the paper lever, and set the paper
correctly.
See "Using Roll Paper" on page 32
Load paper correctly.
See "Using Roll Paper" on page 32
Set the paper lever to the released position,
and remove the paper.
Load a new roll paper.
Restart the printer, and then update the
firmware using EPSON LFP Remote Panel
again.
Remove the jammed paper.
See "The paper is jammed" on page 81
Remove the protective materials from the
print head to release the print head.
See Unpacking and Setup Guide
Turn the printer off, and after a while turn it on
again.
Note the code and contact your dealer.
See "When the maintenance request error
occurs" on page 75
Remove the protective materials from the
print head to release the print head.
See Unpacking and Setup Guide
If the print head is already removed, turn the
printer off, and plug the power cord into the
electrical outlet or the AC inlet of the printer
properly, and then turn the printer on and off a
few times.
Turn the printer off. Plug the power cord into
the electrical outlet or the AC inlet of the
printer properly. Then, turn the printer on and
off a few times. If this message appears on the
LCD panel again, note the code and contact
your dealer.
See "When the service call error occurs"
on page 75
Turn the printer off, leave it for a while, and turn
the printer on again. If this message appears
on the LCD panel again, note the code and
contact your dealer.
See "When the service call error occurs"
on page 75