Epson Stylus Pro GS6000 User Manual page 21

EPSON Stylus Pro GS6000
Details of PAPER SETUP
After you have selected the paper number, make the following settings.
To make the custom paper type settings, see the following section.
"Making the Custom Paper Type Setting" on page 28
Item
PRINT MODE
PAPER FEED ADJUST
HEAD ALIGNMENT
PRE HEATER
User's Guide
The Control Panel
Parameter
MAX QUALITY
QUALITY1
QUALITY2
QUALITY3
SPEED1
SPEED2
SPEED3
LINE FEED ADJUST
PRINT SAMPLE PATTERN
BI-D ALL
OFF
30°C to 50°C (86°F to
122°F)
Explanation
You can select the print quality (print mode) according
to the usage of print data or print speed.
❏
MAX QUALITY, QUALITY1, QUALITY2:
Performs high-quality printing. Use this mode when
printing high quality graphic data that includes
photo data. MAX QUALITY provides priority to print
quality. QUALITY1 is balanced between quality and
efficiency. QUALITY2 provides priority to print
efficiency.
❏
QUALITY3:
Performs standard printing. Use this mode when
printing graphic data.
❏
SPEED1, SPEED2, SPEED3:
Performs high-speed printing. Use this mode when
printing text or graphics. SPEED1 provides priority to
print quality. SPEED2 is balanced between quality
and efficiency. SPEED3 provides priority to print
efficiency.
You can set the paper feed amount of the printable
area. If the paper feed value is too large, white
horizontal micro-banding may appear. If the paper
feed value is too small, dark horizontal micro-banding
may appear.
See "Adjusting Paper Feed" on page 48
You can perform print head alignment. Check the
pattern and enter the value that has the smallest gaps.
See "Aligning the print head using the control
panel" on page 47
You can set the Pre Heater temperature. The Pre Heater
is located under the rear paper guide. Set up to
preheat the paper before printing and insulate the
temperature change in the printer section.
a. Print head, b. Pre Heater, c. Roll paper
Note:
For appropriate temperatures to set to this function, see
the instructions included with the paper, or contact
your supplier.
21
a
b
c