Char-Broil 463271312 Product Manual
  1. Manuals
  2. Brands
  3. Char-Broil Manuals
  4. Grill
  5. 463271312
  6. Product manual
Char-Broil 463271312 Product Manual

Char-Broil 463271312 Product Manual

Performance t-47d
Hide thumbs Also See for 463271312:
Table of Contents

Advertisement

Quick Links

Download this manual
PRODUCT
GUIDE
MODEL
463271312
Char-Broil Performance T-47D
IMPORTANT: Fill out the product record information below.
Serial Number
See ratinglabel on grill for serialnumber.
Date Purchased
Forsupportandto registeryour
grill, pleasevisit us at
www.charbroil.com
If you havequestionsor need
assistanceduringassembly,
pleasecall 1-888-430-7870.
@2011Char-Broil, LLC Columbus,GA 31902
Printed in China
Assembly instructions@2011
07/27/11 QG520-001-160801

Advertisement

Table of Contents
loading

Related Manuals for Char-Broil 463271312

Summary of Contents for Char-Broil 463271312

  • Page 1 PRODUCT GUIDE MODEL 463271312 Char-Broil Performance T-47D IMPORTANT: Fill out the product record information below. Serial Number See ratinglabel on grill for serialnumber. Date Purchased Forsupportandto registeryour grill, pleasevisit us at www.charbroil.com If you havequestionsor need assistanceduringassembly, pleasecall 1-888-430-7870. @2011Char-Broil, LLC Columbus,GA 31902...
  • Page 2 For Your Safety ........If you smell gas: Use and Care ........4-10 1. Shut off gas to the appliance. Limited Warranty ........2. Extinguish any open flame. Parts List .......... 3. Open lid. Parts Diagram ........4. If odor continues, keep away from the appliance and immediately call your gas Assembly ........

  • Page 3: California Proposition

    CAUTION CALIFORNIA PROPOSITION 65 Using pots larger than 6 quarts in capacity could 1. Combustion by-products produced when using exceed weight limit of the side burner shelf this product contain chemicals known to the State of California to cause cancer, birth defects, and other or side shelf, reproductive harm.
  • Page 4 LP Cylinder •The LP cylinder used with your grill must meet the following requirements: •Use LP cylinders only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. • NEVER store a spare LP cylinder under or near •LP cylinders must be constructed and marked in accordance the appliance or in an enclosed area.
  • Page 5 LP Cylinder Exchange Connecting Regulator to the LP Cylinder •Many retailers that sell grills offer you the option of replacing 1.LP cylinder must be properly secured onto grill. (Refer to your empty LP cylinder through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2.Turn all control knobs to the OFF position.
  • Page 6 Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP cylinder. 3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately.

  • Page 7: For Safe Use Of Your Grill And To Avoid Serious Injury

    Safety Tips A Before opening LP cylinder valve, check the coupling nut for tightness. A When grill is not in use, turn off all control knobs and LP For Safe Use of Your Grill and to Avoid Serious cylinder valve. ,I, Never move grill while in operation or still hot.
  • Page 8 Burner Flame Check •Remove cooking grates and flame tamers. Light burners, rotate knobs from Hi to LOW. You should see a smaller flame in LOW position than seen on HI. Perform burner flame check Turn controls and gas source or tank OFF when not on sideburner, also.

  • Page 9: Spider Alert

    General Grill Cleaning CAUTION •Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush SPIDER ALERT! on insides of grill lid and bottom.
  • Page 10 (C) Wear eye protection: Use an air hose to force air into Cleaning the Burner Assembly the burner tube and out the burner ports. Check each Follow these instructions to clean and/or replace parts of burner port to make sure air comes out each hole. assembly or if you have trouble igniting grill.

  • Page 11: Disclaimer Of Implied Warranties

    This warranty only applies to units purchased l¥om an authorized retailer. ManuPacturer warrants to the original consumer-purchaser only that this product shall be fiec from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*.

  • Page 12: Side Shelf

    BOTTOM SHELF LOGO PLATE TANK SCREW, F/BOTTOM SHELF HARDWARE F/TOP LID CASTER, LOCKING LEFT DOOR, NO HANDLE CASTER, FIXED DOOR AND SB HANDLE CART LEFT SIDE PANEL RIGHT DOOR, NO HANDLE GROMMET, F/REGULATOR HOLE FLAME TAMER CART RIGHT SIDE PANEL COOKING GRATE CART LOWER BACK PANEL GRATE, F/SB...
  • Page 13 _CCCc...
  • Page 14 Place bottom shelf upside down. Insert Bent U Pin into the caster mounting plate to lock it in place, shown A. Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Bent U Pin and repeat for remaining casters.
  • Page 15 Place lower back panel between side panels at rear of bottom shelf. Make sure the slots are positioned as shown (A). Secure lower back panel to side panels using two 1/4-20x1/2" screws, 7ram lock washers, and 7ram flat washers on each side. 7turnflat washer 7turnlock washer 1/4-20x1/2"screw Lowerbackpanel...
  • Page 16 On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in lower hole, using one l/4-20xllA '' screw, 7ram lock washer, and 7ram flat washer on each side. Do not fully tighten screws until side shelf installation is complete in later steps. per back panel 1/4-20x11/2"7mmlock 7mmflat screw...
  • Page 17 Insert flange on right side shelf into side shelf brackets on side of firebox, shown A. Attach rear of shelf using one 1/4-20x3/4" screw, 7ram lock washer, 7ram flat washer and 1/4" nut in upper hole; using one l/4-20x11A'' screw, 7ram lock washer and 7ram flat washer in lower hole, shown B/C. Attach front of shelf and fascia using two 1/4-20x3/4"...
  • Page 18 Insert tabs on left sideburner shelf assembly into rectangular slots in side of firebox, shown A, Attach rear of shelf using one 1/4-20x3/4" screw, 7ram flat washer, 7ram lock washer and 1/4" nut in upper hole; and using l/4-20x11A'' screw, 7ram lock washer, 7ram flat washer in lower hole, shown B/C. Attach front of shelf and fascia using two 1/4-20x3/4"...
  • Page 19 Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two l/4-20xllA '' screws, 7ram lock washers, and 7ram flat washers on each side. NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.
  • Page 20 Insert sideburner burner into left shelf. The stud on bottom of burner fits into rear small hole in sideburner drip pan on shelf, shown A. Secure burner to sideburner drip pan with one Wing nut, shown B. Under sideburner shelf, attach sideburner ignitor wire to electrode.
  • Page 21 Inside of cart, insert heat shield rear tabs(without holes) into slots between upper and lower back panels. Then insert left and right grease tray rails into slots beneath grease tray opening in upper back panel. Then insert end of tank wire into right arcuate slot on lower back panel, shown A.
  • Page 22 Inside of cart, insert tank exclusion wire shelf ends into lower back panel, shown A. Attach front left side of wire shelf to the left side panel with one #8-32x3/8" screw, 4ram lock washer and 4ram flat washer. Attach leg to bottom shelf with one #8-32x3/8" screw, 4ram lock washer and 4ram flat washer, shown B. #8-32x3/8"...
  • Page 23 Inside of cart, connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the electronic ignition module. Total (5) connections. Connect the two wires {(a) and (b)} from the switch wiring harness into the back of the electronic ignition module.
  • Page 24 Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door. Hinge pin on bottom ofdoor Install flame tamers by sliding one end of each flame tamer into slots at front of firebox and resting opposite end on pins in back of firebox.
  • Page 25 Place cooking grates onto the firebox as shown. Insert the two wire ends at rear of warming rack into holes in back of firebox. Front wires of warming rack rest on sides of firebox. On back of right side fascia, open battery box by sliding its cover. Put two AA batteries in the box and then replace the cover.
  • Page 26 On back of grill, slide grease tray into opening in upper back panel. CAUTION Failure to install grease tray will cause hot grease to drip from bottom of grill with risk of fire or property damage. Greasetray LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to grill and regulator (see Use & Care section).

  • Page 27: Troubleshooting

    DANGER; If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Gasleakingfrom • Damagedhose. . Turnoff gas at LP cylinderor at sourceon naturalgassystems.If cracked/cut/burned anythingbut burned,replacevalve/hose/regulator. If burned, hose. discontinueuseof productuntila plumberhas investigated cause and corrections are made.

  • Page 28: Electronic Ignition

    Troubleshooting (continued) ELECTRONIC IGNITION: Burner(s)will not light usingignitor. • Nospark,no ignitionnoise. • SeeSectionI of ElectronicIgnitionSystem. (See ElectronicIgnition Troubleshooting a lso) • Nospark,someignitionnoise. • SeeSectionII of ElectronicIgnitionSystem. , Sparks,but notat electrodeor at full • SeeSectionIII of ElectronicIgnitionSystem. strength. Burner(s)will not • See"GAS ISSUES:"on previouspage. matchlight.

  • Page 29: Troubleshooting - Electronic Ignition

    Troubleshooting - Electronic Ignition SECTION I Nosparksappearat • Batterynot installed , Checkbatteryorientation. • Installbattery(makesurethat "+"and "-" anyelectrodeswhen properly. connectorsare orientedcorrectly, w ith "+"end up ElectronicIgnitionButton and "-" enddown.) is pressed;no noise can be heardfromspark , Deadbattery. , Has batterybeen used , Replacebatterywith newalkalinebattery.
  • Page 31 Quel produit enregistrez-vous? Envielo [_Gas Grill l Parrilla a gas l Gril au gaz [_ Electric Grill ] Parrilla el_ctrica ] Gril _lectrique Char-Broil Warranty Registration [_Smoker I Ahumador I Fumoir P.O. Box 1240 [_ Charcoal Grill I Parrilla a carb6n...
  • Page 32 Register your product to receive a special offer www.c h a rbroi i.co m/reg iste r...

This manual is also suitable for:

Performance t-47d

Table of Contents