Char-Broil Performance T-47D Product Manual
  1. Manuals
  2. Brands
  3. Char-Broil Manuals
  4. Grill
  5. TRU-Infrared T-47D
  6. Product manual

Char-Broil Performance T-47D Product Manual

Hide thumbs Also See for Performance T-47D:
Table of Contents

Advertisement

Quick Links

© 2013 Char-Broil, LLC Columbus, GA 31902
PRODUCT GUIDE
MODEL 463273513
Char-Broil Performance T-47D
IMPORTANT: Fill out the product record information below.
Serial Number
Date Purchased
For support and to register your
grill, please visit us at
www.charbroil.com
If you have questions or need
assistance during assembly,
please call 1-888-430-7870.
Printed in China
See rating label on grill for serial number.
Assembly instructions © 2013
10/24/12 • G520-001-250801

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Performance T-47D and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Char-Broil Performance T-47D

Summary of Contents for Char-Broil Performance T-47D

  • Page 1 PRODUCT GUIDE MODEL 463273513 Char-Broil Performance T-47D IMPORTANT: Fill out the product record information below. Serial Number See rating label on grill for serial number. Date Purchased For support and to register your grill, please visit us at www.charbroil.com If you have questions or need assistance during assembly, please call 1-888-430-7870.

  • Page 2: Table Of Contents

    TABLE OF CONTENTS DANGER For Your Safety ........2-3 If you smell gas: Use and Care .

  • Page 3: Grease Fires

    WARNING CAUTION Using pots larger than 6 quarts in capacity could CALIFORNIA PROPOSITION 65 exceed weight limit of the 1. Combustible by-products produced when using side burner shelf this product contains chemicals known to the State or side shelf, of California to cause cancer, birth defects, or resulting in failure other reproductive harm.

  • Page 4: Use And Care

    LP Cylinder USE AND CARE •The LP cylinder used with your grill must meet the following requirements: DANGER •Use LP cylinders only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. •...

  • Page 5: For Your Safety

    LP Cylinder Exchange Connecting Regulator to the LP Cylinder •Many retailers that sell grills offer you the option of replacing 1.LP cylinder must be properly secured onto grill. (Refer to your empty LP cylinder through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2.Turn all control knobs to the OFF position.
  • Page 6 Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP cylinder. 3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately.
  • Page 7 Safety Tips WARNING Before opening LP cylinder valve, check the coupling nut for ▲ tightness. When grill is not in use, turn off all control knobs and LP ▲ cylinder valve. For Safe Use of Your Grill and to Avoid Serious Never move grill while in operation or still hot.
  • Page 8 Burner Flame Check WARNING •Remove cooking grates and flame tamers. Light burners, rotate knobs from HIGH to LOW. You should see a smaller flame in LOW position than seen on HIGH. Perform burner flame check Turn controls and gas source or tank OFF when not on sideburner, also.

  • Page 9: Spider Alert

    General Grill Cleaning CAUTION • Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom.
  • Page 10 Cleaning the Burner Assembly (C) Wear eye protection: Use an air hose to force air into the burner tube and out the burner ports. Check each Follow these instructions to clean and/or replace parts of burner port to make sure air comes out each hole. assembly or if you have trouble igniting grill.

  • Page 11: Limited Warranty

    LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*.

  • Page 12: Parts List

    PARTS LIST Description Description BOTTOM SHELF LOGO PLATE TANK SCREW, F/ BOTTOM SHELF HARDWARE F/ TOP LID CASTER, LOCKING LEFT DOOR, NO HANDLE CASTER, FIXED DOOR HANDLE CART LEFT SIDE PANEL RIGHT DOOR, NO HANDLE GROMMET, F/ REGULATOR HOLE FLAME TAMER CART RIGHT SIDE PANEL COOKING GRATE CART LOWER BACK PANEL...

  • Page 13: Parts Diagram

    PARTS DIAGRAM...

  • Page 14: Assembly

    ASSEMBLY Place bottom shelf upside down. Insert Caster Pin into the caster mounting plate to lock it in place, shown A. Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Caster Pin and repeat for remaining casters.
  • Page 15 Place lower back panel between side panels at rear of bottom shelf. Make sure the slots are positioned as shown (A). Secure lower back panel to side panels using two 1/4-20x1/2” screws on each side. 1/4-20x1/2" screw Lower back panel The vertical flange should be on left side when the lower back panel is properly installed...
  • Page 16 On back of grill, place upper back panel between side panels. Secure upper back panel in lower holes, using one 1/4-20x1½” screw on each side. Do not fully tighten screws until side shelf installation is complete in later steps. 1/4-20x1 ½" screw Upper back panel Insert temperature gauge stem into the bigger hole above knob, shown A.
  • Page 17 Insert flange on right side shelf into side shelf brackets on side of firebox, shown A. Attach front of shelf and fascia using three 1/4-20x1/2" screws with 1/4" nuts and using one #8x3/8” self-tapping screw with large flat washer, shown B/C/E. Attach rear of shelf using one 1/4-20x1/2”...
  • Page 18 Insert flange on left sideburner shelf into side shelf brackets on side of firebox, shown A. Attach left sideburner shelf using three 1/4-20x1/2” screws and 1/4” nuts, shown B. Attach rear of shelf using one 1/4-20x1 ½" screw, shown C. Attach front of shelf using one #8x3/8”...
  • Page 19 First, remove the two screws and washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using screws and washers that were removed from bracket.
  • Page 20 Under sideburner shelf, attach sideburner ignitor wire to electrode, shown A. Place sideburner grate onto sideburner shelf, aligning grate legs with holes in shelf, shown B. Sideburner grate Electrode Sideburner Ignitor Wire Insert front brace under control panel and between cart panels. Make sure door hinge pin is on the top side and facing the front.
  • Page 21 Inside of cart, insert heat shield rear tabs(without holes) into slots between upper and lower back panels. Then insert left and right grease tray rails into slots beneath grease tray opening in upper back panel. Then insert end of tank wire into right arcuate slot on lower back panel, shown A. Attach left and right rails to the bottom of front brace with two #8X3/8”...
  • Page 22 Inside of cart, insert tank exclusion wire shelf ends into lower back panel, shown A. Attach front left side of wire shelf to the left side panel with one #8-32x3/8” screw. Attach leg to bottom shelf with one #8-32x3/8”screw, shown B. Tank exclusion wire shelf #8-32x3/8"...
  • Page 23 Inside of cart, connect each of the wires from main burner electrodes and sideburner electrode into the back of electronic ignition module. Total (5) connections. Connect the two wires {(a) and (b)} from switch wiring harness into the back of the electronic ignition module. Total (2) connections, shown A.
  • Page 24 Attach door handle to left door using two #10-24x3/8" screws. Repeat above for right door. Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door. Left door #10-24x3/8"...
  • Page 25 Place IR cooking grates onto the firebox as shown. Insert the two wire ends at rear of warming rack into holes in back of firebox. Front wires of warming rack rest on sides of firebox. IR cooking grate Hang IR cleaning tool on the slot of right door back panel. Right door IR Cleaning tool (For IR cooking grate)
  • Page 26 On back of grill, slide grease tray into opening in upper back panel. CAUTION Failure to install grease tray will cause hot grease to drip from bottom of grill with risk of fire or property damage Grease tray LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to grill and regulator (see Use &...

  • Page 27: Troubleshooting

    DANGER: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from • Damaged hose. • Turn off gas at LP cylinder or at source on natural gas systems. If cracked/cut/burned anything but burned, replace valve/hose/regulator.
  • Page 28 Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light ELECTRONIC IGNITION: using ignitor. • No spark, no ignition noise. • See Section I of Electronic Ignition System. (See Electronic Ignition Troubleshooting also) • No spark, some ignition noise. • See Section II of Electronic Ignition System. •...

  • Page 29: Troubleshooting

    Troubleshooting - Electronic Ignition Problem (Ignition) Possible Cause Check Procedure Prevention/Solution SECTION I No sparks appear at • Battery not installed • Check battery orientation. • Install battery (make sure that “+” and “–” any electrodes when properly. connectors are oriented correctly, with “+” end up Electronic Ignition Button and “–”...
  • Page 30 NOTES...

This manual is also suitable for:

463273513463271313

Table of Contents