Char-Broil 463271312 Product Manual page 8

Turn controls and gas source or tank OFF when not
in use.
CAUTIo.
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF,wait 5 minutes and repeat the
lighting procedure, if the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match-Lighting
A Do not lean over grill while lighting.
1. Turn OFF all gas burner control valves.
2. Turn ON gas at LP cylinder.
3. Open lid during lighting.
4. Push in and turn the AUTO-CLEAN
TM
valve to the GRILL position.
5. Place match into match holder (hanging from side panel of
grill). Light match; then light burner by placing match through
the match light hole on right or left side of grill.
6. Push in and turn far right or far left burner knob to the HI
position, depending on match light hole selected. Be sure
burner lights and stays lit.
7. Light adjacent burners in sequence by pushing knobs in and
turning to the HI position.
NOTE: Your grill may NOT be equipped with a Sideburner!
Sideburner Ignitor Lighting
A Do not lean over grill while lighting.
1.Open sideburner lid. Turn ON gas at LP cylinder.
2.Push in and turn the AUTO-CLEAN
TM
valve to the GRILL position.
3.Turn sideburner knob to HI, push and hold ELECTRONIC
IGNITOR button.
4.If sideburner does NOT light, turn knob to OFF, wait 5 minutes,
then repeat lighting procedure.
Sideburner Match Lighting
A Do not lean over grill while lighting.
1.Open sideburner lid. Turn ON gas at LP cylinder.
2.Push in and turn the AUTO-CLEAN
TM
valve to the GRILL position.
&Place lit match near burner.
4.Turn sideburner knob to HI.
Be sure burner lights and
stays lit.
Burner Flame Check
•Remove cooking grates and flame tamers. Light burners, rotate
knobs from Hi to LOW. You should see a smaller flame in
LOW position than seen on HI. Perform burner flame check
on sideburner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden drop or low flame" in
the Troubleshooting Section.
Turning the Grill OFF with AUTO-CLEAN
TM
With the Autoclean feature you have two choices for turning off your
grill; Manual and AUTO-CLEAN
TM
Manual Method
o Turn all knobs, including the AUTO-CLEAN
TM
valve, to the OFF
position.
o Turn OFF the LP cylinder by turning the handwheel clockwise to a
full stop.
NOTE: Always follow the lighting instructions found in the instruction
manual and also located on the inside of the cabinet door prior to
using the Auto-Clean feature. Grill must be ignited prior to using the
Auto-Clean feature.
AUTO-CLEAN
TM
Method
o After cooking is complete, set all main burner grill knobs to the
high setting and close the grill lid. (AUTO-CLEAN
TM
shutdown
should not be used on the sideburner.)
o Push in and turn the AUTO-CLEANrM knob to the clean position.
o Once at the clean position, release the knob and the green light
should begin blinking.
o The valve will now stay on for 15 minutes before turning off the
gas to the burners.
o After the clean cycle is complete, turn all knobs including
the AUTO-CLEAN
TM
valve to the OFF position.
o Turn OFF the LP cylinder by turning the handwheel clockwise to a
full stop.
For safety in storing a grill, the LP cylinder should always be turned
OFF
If red light comes on while green light is flashing, the batteries will
need to be replaced very soon.
When changing the batteries, please replace both batteries at the
same time. Always replace with newbatteries of the same type.
Ignitor Check
•Turn gas off at LP cylinder. Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between each collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
•important: Make sure gas is off at LP cylinder before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back to
OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut, worn or kinked.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.