Figure 2-23 Main Terminal Window - Xantrex GRIB and Ethernet interface Operating Manual

M370078-06
5. In the Connect using: box, select "TCP/IP (Winsock)".
6. In the Host address box, enter the IP address, obtained in step 14 of
the section entitled "Assigning an IP Address to the Power Supply
Unit" on page 2–12.
7. In the Port number box, enter "10001" as the value.
8. Click OK.
To specify the terminal connection properties:
1. Click Disconnect if necessary, and click Properties in the main
HyperTerminal window. See Figure 2-23.

Figure 2-23 Main Terminal Window

2. In the ENET Properties window, click on XGthe Settings tab. See
Figure 2-24.
Terminal Configuration
2-21