Assigning An Ip Address To The Power Supply Unit; Figure 2-13 Selecting Network Adapter; Figure 2-14 Auto-Ip Address Message - Xantrex GRIB and Ethernet interface Operating Manual

Ethernet (ENET)

Assigning an IP Address to the Power Supply Unit

2-12

Figure 2-13 Selecting Network Adapter

If your system is auto-IP configured, the following warning message is
displayed:

Figure 2-14 Auto-IP Address Message

Auto-IP mode is acceptable only for the single computer and
Important:
single power supply configuration.
To assign an IP address to the power supply unit:
1. Click OK to dismiss the Auto-IP warning message. If you are not
intending on using an Auto-IP, debug your network connection at this
time.
The Lantronix DeviceInstaller window appears. See Figure 2-15.
M370078-06