Installing Operator Panel - Epson RC170 Manual

The Operator Panel is designed for vertical installation. It can also be installed at an angle.
-
However, in this case, limit the angle of tilt from the vertical within 30 deg.
- If the Operator Panel is installed at an angle of tilt exceeding 30 deg, take measures, such
as forced air cooling, to prevent the operating ambient temperature from exceeding 40
degC.
- Do not install the Operator Panel horizontally.

3.2.3 Installing Operator Panel

(1)
(2) Insert the hook of the mounting metal hasps into the four mounting holes at the top and
(3)
OP1 Rev.1a
Within 30deg.
Set the Operator Panel into the panel cutout
from the front.
bottom of the Operator Panel.
Mounting Holes
Slide the mounting metal hasps towards the rear.
3. Installation
11