Print Size And Page Size; Duplex Printing - Kyocera TASKalfa 181 User Manual

Print Size and Page Size

Duplex Printing

KX DRIVER
Transparencies must be printed using the MP tray, and labels and envelopes
require the MP tray. Ensure the paper is properly loaded by following the
instructions outlined in the printing system's Operation Guide.
Note: Source and Media type are separate items in the dialog box, but can
be combined using the Combine source and media type lists setting in
Compatibility Settings. If they are combined, Media type is not available on
the Basic tab. To change this setting, open Device settings > Compatibility
Settings and clear the Combine source and media type lists selection.
Print Size controls the output page size of the document. To use this setting,
ensure that the Page Size setting matches the page size setting in your
application. If the Print Size is different from the page size in your application,
then each page will be enlarged or reduced to match the Print Size. The
percentage value shown in brackets indicates the size of the Print Size setting
relative to the Page Size setting. If the Page Size does not match the page size
setting in the application (the size of the original), then, in most cases, the Print
Size is ignored and the document prints out based on its original size.
Duplex printing is printing on both sides of each page. Select Print on both
sides to start duplex printing. If it is not selected, then the printer prints on only
one side of each page. The printer system contains a duplex unit that turns the
paper over to allow printing on the reverse side. Print on both sides must be
selected to print on both sides of the cover and insert pages.
Flip on long edge
Turn the long edge of the page to view the content, like the pages of a book
bound at the side.
Flip on short edge
Turn the short edge of the page to view the content, like a tablet bound at the
top.
Flip on long edge
Basic
4-3