Label Receipt Usage; Paper Cutting And Head Pulling Out Function - Epson TM-L90 Series Development Manual

3.19 Label Receipt Usage

Please specify the paper with the Memory Switch. To use the function related
to the label, the paper should be label paper or black mark paper.
When using label receipt paper, the Escape Sequence ESC|#IF feeds the
receipt the specified length, or to the head of the next label.

3.20 Paper Cutting and Head Pulling Out Function

The TM-L90 models have a function to continuously cut paper and pull out its
head. First, the printer feeds the paper to the cutting position when this function is
used. Next, it cuts the paper using the specified cutting rate. Finally, it pulls out
the head of the paper and the operation ends. Because the printer pulls out the
head of paper after cutting it, the blank on the paper at the upper side can be
reduced. This function can be used only if the receipt paper is set to the paper
setting. This function can be used by the PTR_DI_CUT_AND_FEED_TOF
command of DirectIO. Though the cutting rate can be specified using the pData
parameter of DirectIO, for the TM-L90, the cutting rate does not change according
to the value of pData, because the cutting rate depends on the installed position
of the auto cutter unit. However, when values other than 0 to 100 are specified for
pData, OPOS_E_ILLEGAL (OPOS_EX_BADPARAM + 2) is returned.
29
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-L90)
Version 3.00 Feb. 2019