Table of Contents
Advertisement
Using the Learn Function
You can program
the DSS remote
commander
to learn
the functions
of
another
component's
remote
control.
Use this function
to operate
components
that are not listed
in "Programmable
Codes"
on page
80.
To use the Learn function:
1
Set the slide switch in the inside panel to VTR3 or MDP.
2
Place the DSS remote commander
and the other component's
remote control directly facing each other, about two inches apart.
%
Approx. 2 inches__
3
Press the LEARN button. The Learn indicator lights.
4
Press the button on the DSS remote commander that you want to
]earn a function. The Learn indicator flashes off, then on, indicating
that the DSS remote commander is now ready to ]earn.
5
Hold down the corresponding
button on the other component's
remote control. When the Learn indicator flashes off, then on,
release the button on the other component's remote control
If the indicator doesn't flash, repeat steps 4 and 5.
6
To learn other functions,
repeat steps 4 and 5.
About
the Learn Function
The Learn function does not work in the VTR1 and VTR2 slide
switch positions.
During the learning
procedure,
do not move the remote controls.
If you press a button on this remote commander
that cannot be
used for learning,
the Learn indicator
flashes four times.
_i
To clear all learned signals from memory, set the slide switch inside
the lid to MDP, press the LEARN button, press the DSS POWER
button while holding
down the VOL- button, and then press the
LEARN button
again.
When you remove the batteries
-- to replace them, for example
--
any codes you've set may be erased.
82
Appendix:
Other
Information
Advertisement
Table of Contents
