Sony DSS SAT-A1 Operating Instructions Manual page 71

Step 2: Set the DSS Remote Control's RF Security Code
1
Press the CODE SET button on the DSS remote control.
2 Using the number buttons on the DSS remote control, enter the
three-digit security code you selected for the DSS receiver in step 3
on page 70.
3 Press the ENTER button on the remote control.
The RF security code is now changed for both the DSS receiver and
remote control.
To Determine the Current
Security Code for the DSS
Remote Control
You can determine the current RF security code for the DSS remote
control using the IDENTIFY button in the Set Up remote screen.
1 Bring up the Setup Remote screen, as described on page 69.
2 Select IDENTIFY.
SETUP REMOTE
REMOTE SIGNAL RFONLY
RFSECURITY CODE 009
Pressthe joystick within 5 seconds.
3
When the message "Press the joystick within 5 seconds" appears,
press the joystick before the 5 seconds expire.
The current RF security code for the DSS remote control appears.
SET UP REMOTE
REMOTE SIGNAL RFONLY
RFSECURITY C ODE I 009
I
Yourremote is currently set at 000.
Note
If the message, "Security code could not be identified" appears, check to make
sure that RF is enabled. See "Selecting IR/RF Transmission" on page 69.
4 Select OK to return to the Installation Menu.
Chapter 6: Using the Installation Menu 71