Set Up For Use; Channel Set Up (Automatic) - Sylvania SRV206 Owner's Manual

SET UP FOR USE
You can program the tuner to scan only the channels you
receive in your area.
NOTES:
• Channel memory programming is NOT
needed when connected to a cable box or satel-
lite box as in Fig 4 on page 11 or Fig 5 on
pagel2. In this case with your remote, select the
VCR to channel 3 or 4 the same channel as lo-
cated on the back of VCR (CH3 or CH4). Then
the channel you wish to record or view may be
selected on the cable box or satellite box.
• Follow the steps below once. Repeat it only if
there is a power failure or if the VCR is unplugged
for more than 30 seconds. (In these cases, the pro-
grammed channels are erased.)
• You must follow the steps below before attempt-
ing to play or record a video tape. If you want to
play or record a video tape BEFORE program-
ming the tuner, you can cancel it by pressing the
RESET/EXIT button. To program the tuner again,
see "CHANNEL SET UP AGAIN" on page 16.
d Select "ENGLISH" or "ESPAI_IOL"
Select "ENGLISH" or I _*_+_"°2 ]
' "ESPAIqOL"=Spanish by using "_'_ '°"+
the PLAY/h, or STOP/• button. Es,,_
Then, press the F.FWD/I_ but-
ton.
Note: This function effects only the language on the
screen menu and not the audio source.
Press the EFWD/I_ button once. _, I t
AUTOS[CUP
The (uner scans and memorizes / I _.
all active channels in your area.
• The VCR distinguishes between standard TV chan-
nels and cable channels.
++++ i +o 1
The tuner stops on the lowest
memorized channel. The TV
screen returns to TV mode.
1
Plug in the VCR power cord
Plug the VCR power cord into a stand-
ard AC outlet.
Remember: If your cable box or satellite box is con-
nected as in Fig 4 on page I I or Fig 5 on
page 12, you DO NOT have to set up the
channels. Just select the TV and VCR to
channel 3 or 4 and also have the
CH3/CH4 switch on the back of the VCR
to match the channel you selected (CH 3
or CH 4). Now select the Box to the chan-
nel you wish to view or record.
2
Select chanr_el 2 or ,: on the TV
Turn on the TV and set the TV to channel 3
or 4. Now set the CH3/CH4 switch on the
back of the VCR to match the channel se-
lected on the TV.
[Back of
the VCR]
• If "AUTO SET UP" appears on the TV screen again,
check the cable connections. Press the F.FWD/I_-
button once again and the VCR will begin preset
again.
TO SELECT A DESIRED CHANNEL
You can select the desired channel by using the CHAN-
NEL • or • button or directly pressing the number but-
tons on the remote control.
Note for using the number buttons:
• When selecting cable channels which are higher than
99, press the + 100 button first, then press the last two
digits. (Example: to select channel 125, first press the
+100 button then press "2" and "5").
• You must precede single-digit channel numbers with
a zero (For example: 02, 03, 04 and so on).
3 Turn on
the u'CR
Press the POWER button to turn on the VCR. Both the
POWER indicator and the VCRFfV indicator on the
VCR come on.
-14-
EN
9J27
H59M5