SET UP FOR USE
You can program the tuner to scan only the channels you
receive in your area. You must use the remote control
for this procedure.
NOTES:
• Channel
memory
programming
is NOT
needed when connected to a cable box or satel-
lite box as in Fig 4 on page 11 or Fig 5 on
page12. In this case with your remote, select the
VCR to channel 3 or 4 the same channel as lo-
cated on the back ofVCR (CH3 or CH4). Then
the channel you wish to record or view may be
selected on the cable box or satellite box.
• Follow the steps below once. Repeat it only if
there is a power failure or if the VCR is unplugged
for more than 30 seconds. (In these cases, the pro-
grammed channels are erased.)
• You must follow the steps below before attempt-
ing to play or record a video tape. If you want to
play or record a video tape BEFORE_ program-
ming the tuner, you can cancel it by pressing the
RESET/EXIT button. To program the tuner again,
see "CHANNEL SET UP AGAIN" on page i6.
1 Plug in the VCR power cord
Plug the VCR power cord into a stand-
ard AC outlet.
Remember:
If your cable box or satellite box is con-
nected as in Fig 4 on page 11 or Fig 5 on
page 12, you DO NOT have to set up the
channels. Just select the TV and VCR to
channel
3 or 4 and also have the
CH3/CH4 switch on the back of the VCR
to match the channel you selected (CH 3
or CH 4). Now select the Box to the chan-
nel you wish to view or record.
2
Select channel 3 or 4 on the TV
Turn on the TV and set the TV to channel 3
or 4. Now set the CH3/CH4 switch on the
back of the VCR to match the channel se-
lected on the TV.
[Back of
the VCR]
3
Turn on the VCR
Press the POWER
button to turn on the VCR. Both the
POWER
indicator
and the VCR/TV
indicator
on the
VCR come on.
• Use the remote control for this procedure.
+
4 Select *'ENGLISH"or "ESPAI_IOL"
"ESPA!qOL"=Spanish
by using
_ _,_
{_
the PLAY/A or STOP/V button.
Then, press the EFWD/I_- but-
ton.
Note: This function effects only the language on the
screen menu and not the audio source.
5
Begin channel preset
Press the EFWD/I>- button once.
The tuner scans and memorizes
all active channels in your area.
• The VCR distinguishes between standard TV chan-
nels and cable channels.
6Aerscannn
I OH011
The tuner stops on the lowest
memorized
channel.
The TV
to TV mode.
• If "TUNER SET UP" appears on the TV screen
again, check the cable connections.
Press the
F.FWD/I_- button once again and the VCR will begin
preset again.
I TO SELECTA
DESIRED
CHANNEL
You can select the desired channel by using the CHAN-
NEL • or • button or directly pressing the number but-
tons on the remote control.
Note for using the number buttons:
• When selecting cable channels which are higher than
99, press the +100 button first, then press the last two
digits. (Example: to select channel 125, first press the
+100 button then press "2" and "5").
• You must precede single-digit channel numbers with
a zero (For example: 02, 03, 04 and so on).
- 14-
EN
8J27