Table of Contents
Advertisement
3)
If your TV does not have A/V terminals:
I
When the VCR is in the Playback
mode or when the !
VCR is in the VCR position, your TV will receive sig-
4)
nals from the VCR on either channel 3 or 4.
i •
To use the VCR with your TV, set the selector switch to
CH3 or CH4 (which is located in the beck of your VCR),
whichever
is not used for normal broadcasts
in your
•
area. Then set your TV to the same channel.
[Back of the VCR]
Connect the audio/video
cables to the audio/video
input jacks on the back of the VCR. Now connect the
other end of the cables to the audio/video output jacks
on the source.
If you use the audio and video input jacks on the
back of the unit, press 0, 0, 1 on the remote control
to select the "Lineln Rear (L I)" position.
If you use the audio and video input jacks on the
front of the unit, press 0, 0, 2 on the remote control
to select the "Lineln Front (L2)" position.
You may also select the "Lineln
Rear (L1)" or
"Lineln Front (L2)" setting by pressing the CHAN-
NEL • or • button.
Notes:
• When the TV screen displays "Lineln Rear (LI)" or
CONrqECTING
TO INPUT JACKS
"Lineln Front (L2)", its background will be blue.
• "Lineln Rear (L1)" or "LineIn Front (L2)" is found be-
When you copy a video tape, or watch a program re-
fore the lowest memorized channel. (Example: CH2)
corded on an another source, use the audio/video input
jacks on the VCR.
CONNECTING
TO OUTPUT
JACK,S
• When you connect a monaural VCR (another source)
to this VCR, connect the Audio output jack of the
lfyour
TVhasA/Vinputjacks,
monaural VCR (another source) to the AUDIO IN L
You may connect your VCR's AUDIO/VIDEO OUTPUT
jack of this VCR. The audio signal will be recorded
jackstotheaudio/videoinputjacksonbeckofyourTV.
in both L and R channel equally.
Direct audio/video connections
usually result in a better
USING
THE REAR JACK:
[ Fi_.7:
TO the audio
USING THE FRONT JACK:
picture and sound quahty for tape playback. Please see
I [y°urFilil.8:TV's
owner's manual for A/V input connections.
I
--trio
You can use the audio and video input jacks on the front
panel of the VCR instead of using the jacks on the back.
INPUT
SELECT
OF FRONT
OR REAR
To use the audio/video
input jacks, select the "Lineln
Rear (L l)" or "Lineln Front (L2)" position.
1) Be sure to check that the POWER and the VCR/TV
indicators are both on.
I) Open the battery compartment
cover by pressing the
cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery com-
partment
in the direction indicated by the polarity
(+/-) markings.
3) Replace the cover.
2) Turn on the TV and set the TV to channel 3 or 4. Now
set the CH3/CH4
switch on the back of the VCR to
match the channel selected on the TV.
-13-
EN
9J27
H59M5
Advertisement
Table of Contents
