Table of Contents
Advertisement
RECORDING
• Please
refer to the connection
you are using,
through pages 10, lI, or 12 on "ANTENNA/CA-
BLE CONNECTIONS"
before continuing.
• Be sure to check that the POWER and the VCRflW
indicators are both on.
• Turn on the TV and set the "IVto channel
3 or 4. Now set the CH3/CH4 switch on
the back of the VCR to match the channel
[Back of
selected on the TV.
theVCR]
• Insert a cassette tape with its erase prevention tab in
place. (If necessary,
rewind or fast forward the tape
to the point at which you want to begin recording.)
• You must select the recording mode in TV STEREO
or SAP when you record a broadcast• Refer to "SE-
LECTING THE MTS SYSTEM" on page 18.
Press the PAUSE/STILL
button
I 'q'_'*'_
]
to temporarily
stop recording•
Press the PAUSE/STILL
or RE-
CORD button to resume record-
ing•
NOTE:
When the VCR is in the Pause mode, you may
view the pause time remaining with • marks
on the TV screen• Each • mark represents one
minute• After five minutes, the VCR will auto-
matically switch to the Stop mode to prevent
tape damage• When there is 1 minute remain-
ing, one • will flash.
!
Select the channel to be recorded
Press the number buttons on the
remote
control
or the CHAN-
NEL • or • button.
CH32 1
NOTE:
If you have a cable box or satellite box con-
nected to this VCR, please refer to "AN-
TENNA/CABLE
CONNECTIONS" on pages
11 and 12 before proceeding to the next step.
2
Select the tape speed
_
L,
Press the TAPE SPEED button
on the VCR to select the desired
tape speed (SP/SLP).
3 Begin recording
(.Ec
Press the RECORD
button. The
RECORD indicator on the VCR
comes
on.
s_
NOTE:
If any menu is activated on the TV screen, the
RECORD button on the remote control does not
function• Press the RESET/EXIT button to clear
the menu. Then, press the RECORD button•
4 Sop recording
Press the STOP button when recording is completed•
You can record one program while viewing another. To
start recordi ng, follow steps [ 1]to [3] under "VIEWING
AND RECORDING
THE SAME PROGRAM".
To select the channel you want to view at the TV, follow
the steps below.
NOTE:
If you have a cable box or satellite box con-
nected to this VCR, please refer to "AN-
TENNA/CABLE
CONNECTIONS" on pages
11 and 12 before proceeding to the next step.
4
Select the TV mode
Press the VCR/TV button so that the VCRFFV indicator
on the VCR disappears.
5
Select the channel on the TV
Set the TV to the channel you want to watch•
l) Press the VCR/TV button so that the VCR/TV indi-
cator on the VCR comes on.
2) Turn on the TV and set the TV to channel
3 or 4. Now set the CH3/CH4 switch on
the back of the VCR to match the channel
IBackof
selected on the TV.
theVCR]
- 24 -
EN
9J27
H59M5
Advertisement
Table of Contents
