Table of Contents
Advertisement
1.5
Installing the Personality Module (only Printer CI - 4050)
The printer functions only in combination with an installed interface module,
called a Personality Module (PM).
The illustration below shows the standard PM with a serial and parallel interface.
-
To avoid damage due to electrostatic discharge, do not touch the pins
Note
or components of the PM.
-
Never attempt to install or remove a PM while the printer is switched
ON.
1. Remove the PM (1) from its packaging.
2. Insert the Personality Module (1) with the component side upwards until the
connector fully engages. Hand tighten the two lock screws (2).
Getting Started
1-7
Advertisement
Table of Contents
