Table of Contents
Advertisement
Printer Operation
How to Use this Function
Preprinted paper (e.g. bill of lading) has to be adjusted exactly. Following
errors are possible:
- the printed value is too high - the fanfold paper has to be moved a little
bit higher.
- the printed value is too low - the fanfold paper has to be moved a little
bit lower. No backward movement is possible for a form in park position
or with the print head on the first line. The displacement will become
effective on the next page. A negative displacement is possible if this
function is used during a current print job (not at the beginning of the
page).
After pressing
all other cases the paper remains at its actual position. Each further
pressing of
further pressing of
inch. Holding of
1
( / inch), thereafter in multiplier of ten which results in a continuous
60
increment or decrement of the offset counter by / inch. If the reached
value is too high go backwards by pressing
The offset to the current position is shown on the display. Dependent on
the status of the internal print buffer, the offset will be immediately
executed after having resumed the printing or after having printed the
remaining data in the internal print buffer. The offset value is not stored in
the configuration set up and influences only the actual line counter. The
maximum displacement range is the distance between the actual position
and the page border plus one full page, but no more than 999 steps (nearly
1 inch). A backward movement is possible from the actual position to the
top of that page.
If the setting is procedure is completed change with
or BUSY mode.
2-6
again, paper is fed in case it was in the park position. In
increases the line counter by increments of / inch. Each
decreases the line counter by decrements of /
or
causes the first 20 increments in single steps
1
60
1
6
.
(93) to the READY
1
60
Advertisement
Table of Contents
