Removing the Power Button Board
1. Perform the
"Removing the Lower
2. Perform the
"Removing the Battery
3. Release the latch (1) from the mainboard then disconnect the power button cable (2).
Figure 3-58. Power Button Cable
4. Release the power button board from the adhesive tape securing it (1) then tilt the power
button board (2) and detach it from the upper case.
Figure 3-59. Power Button Board Adhesive Tape
NOTE:
NOTE:
A circuit board that is > 10cm
Figure
3-59. Follow the local regulations for disposing this type of circuit board.
3-38
Case" procedure described on page 3-9.
Pack" procedure described on page 3-10.
2
has been highlighted with a yellow rectangle in
0
Machine Maintenance