Removing the WLAN Board
NOTE:
NOTE:
For models that have M-SATA board installed, please proceed to page 3-35,
the M-SATA
1. Perform the
"Removing the Lower
2. Perform the
"Removing the Battery
3. Perform the
"Removing the WLAN
4. Release the connector latches (1) from the WLAN board, then disconnect the WLAN &
mini 1 cables (2). Disconnect the power cable from the WLAN board (3).
Figure 3-50. WLAN, Mini 1 & Power Cables
5. Detach the WLAN board from the upper case.
Figure 3-51. WLAN Board
NOTE:
NOTE:
A circuit board that is > 10cm
Figure
3-51. Follow the local regulations for disposing this type of circuit board.
3-34
Board".
Case" procedure described on page 3-9.
Pack" procedure described on page 3-10.
Module" procedure described on page 3-15.
2
has been highlighted with a yellow rectangle in
0
"Removing
Machine Maintenance